Omron E5AK Datasheet page 10

• E5EK
1. Remove the power board and option boards in the order shown in
the following diagram.
2. Insert the Option Unit into the socket for option 1. The following
diagram shows the relationship between the Option Unit and
mounting position.
3. Mount the option board and the power board in the order shown.
10
Digital Controller
Option 1
E53-AKB: Event inputs 1/2
E53-EN01: RS-232C
E53-EN02: RS-422
E53-EN03: RS-485
E53-AKF: Transfer output
E5AK/E5EK
Draw-out
To draw out the internal mechanism from the housing, use a Phillips
screwdriver matching the screw on the lower part of the front panel.
1. Turn the screw counterclockwise while pressing the hook on the
upper part of the front panel.
2. Draw out the internal mechanism while holding the left and right
sides of the front panel.
Mounting
1. Insert the E5AK Controller into the panel's mounting hole at the
position shown in the figure below.
2. Fit the mounting bracket (accessory) into the fixing slots on the
top and bottom of the rear case.
3. Tighten the mounting bracket screws on the upper and lower
parts of the E5AK in small increments alternately and equally until
the ratchet start to slide.
Hook