Initial Alternative Configuration Through Web Client - golmar iPG+ 6502/G+ Installer Manual

IP G+ CATEGORY 2_HEADER
In systems with general entry panels, will require to follow the same process described before, but in step 6, the number of building
should be 99. The number of entry panel will run from 1 to 19 (max. number of general entry panel is 19).
It follows the explanations on how to review the registered configuration.
1
Marcar el número de vivienda
o pulsar para mostrar la agenda
Access to configuration.
(*) Check the quick guide of the monitor to know the monitor's configuration, in order to communicate with the panel.
6. ALTERNATIVE INITIAL CONFIGURATION THROUGH WEB CLIENT.
6502/G+ coded panel can be configured via its web client.
To do this, you need to connect your computer to the network.
The factory IP address of the panel is 10.0.0.254. Check that your computer network connection is in the same range. You will perform
the following steps:
1
Go to network settings in control panel.
3
Enter into "properties".
Footer Infos www.golmar.es
2
Introducir contraseña
Type the installer PIN code
2718 with the keypad and press validate.
Edi cio
Placa
Dirección IP
Máscara de red
Puerta de enlace
Dirección Mac
4
Select Internet
protocol IPv4.
3
Menú de ajustes
Press the right arrow button to
go to settings menu (3/3).
2
Change the active Ethernet network.
5
Set the IP range.
Do not assign DNS
6502/G+
CATEGORY 1_HEADER
4
Menú de ajustes (3/3)
Select the fourth option.
Block and door panel
number set.
IP address should start by 10.
Next three numbers should
have a value lower than 255.
Assign 10.0.0.1 as Gateway.
Confirm settings.
6 6