Specification - Omron E3FR Datasheet

Specification

Item
Sensing distance
Spot diameter
Standard sensing object
Differential travel
Black/white error
Directional angle
Light source (wave length)
Power supply voltage
Current consumption
Control output
Protective circuits
Response time
Sensitivity adjustment
Ambient illumination
(receiver side)
Ambient temperature
Ambient humidity
Insulation resistance
Dielectric resistance
Vibration resistance
Shock resistance
*1
Degree of protection
Connection method
Indicator
Weight Pre-wired
(packed state)
Standard
connector
Material Case
Cover-lens
Plate-window
Accessories
*1.
The IP69k test according to DIN 40 050 part 9 is intended to simulate high pressure/steam cleaning. During the test 14-16 l/min water
at 80ºC is sprayed onto the sensor from different angles with 8000-10000 kPa. The sensor may not suffer any damaging effects from
high pressure water in appearance and functionality.
E3FZ/E3FR
Background suppression (BGS)
E3FZ-LS@1H / E3FR-LS@1H
E3FZ-LS@6H / E3FR-LS@6H
10 to 100 mm (White paper 100x100 mm)
4 mm dia. at sensing distance of 100 mm
–
3% of sensing distance max.
5% of sensing distance max.
–
Red LED (650 nm)
10 to 30 VDC, including 10% ripple(p-p)
25 mA max.
Load power supply voltage; 30 VDC max., Load current; 100 mA max. (Residual voltage; 2 V max.),
Light-on/Dark-on selectable by wire,
E3F@-LS6: NPN open-collector output
E3F@-LS8: PNP open-collector output
Power supply reverse polarity protection, output short-circuit protection,
mutual interference prevention and reversed output polarity protection
Operate and reset; 1 ms max.
–
Incandescent lamp; 3000 lx max., Sunlight 10000 lx max.
Operating; -25 to +55°C, Storage; -40 to +70°C (with no icing or condensation)
Operating; 35 to 85%RH, Storage; 35 to 95%RH (with no condensation)
20MΩ min. at 500 VDC
1000 VAC at 50/60 Hz for 1 min
Destruction; 10 to 55 Hz, 1.5 mm double amplitude for 2 hours, each in X, Y and Z directions
2
Destruction; 500m/s , 3 times, each in X, Y and Z directions
IEC 60529 IP67, IP69K after DIN 40050-9
Pre-wired cable (standard length 2m), Standard M12 connector
Operation indicator: yellow, stability indicator: green
approx.60g
approx.20g
ABS
PMMA
Instruction sheet, 2x M18 nuts, snap mounting tool (E3FZ only).
E3FZ-LS@4H / E3FR-LS@4H
E3FZ-LS@9H / E3FR-LS@9H
10 to 200 mm (White paper 100x100 mm)
18 mm dia. at sensing distance of 200 mm
20% of sensing distance max.
20% of sensing distance max.
Red LED (660 nm)
7