Mifare Rfid Reader Configuration; Add Master Card; Factory Reset - ITS Telecom EKSELANS KIT HOME WIFI User Manual

Single-family video intercom kit
Table of Contents

Advertisement

HOME WIFI KIT USER MANUAL

4.4 Mifare RFID Reader Configuration

Inside your KIT Home, you will find a Mifare RFID configuration master key. To add access keys,
simply pass the master key and it will produce a first-read BEEP and then issue BEEP's
indicating that it is in access card recording mode. Once the card recording mode is activated,
pass as many cards as you want to add to your installation.
Once finished, hover the master card again to exit the mode.

4.4.1 Add Master Card

In case of loss of master card, you have the possibility to add one again. On the back of the PE
1BM entrance panel you will find a button to enable this mode.
Press and hold for 5 seconds until you hear a long BEEP. Swipe the card and you'll hear again in
long confirmation BEEP.
Note: Only one master key can be configured in the installation.

4.4.2 Factory Reset

To erase all Mifare RFID access cards from the PE 1BM entrance panel, press and hold the
button on the back for 10 seconds.
Important: This factory reset will erase including the configured master card. To reconfigure it,
go to section 4.4.1
ITS Partner O.B.S S.L · Av. Cerdanyola 79-81 Local C
11
08172 Sant Cugat del Vallés · Barcelona (Spain) Phone:
+34935839543 · info@ek.plus · www.ek.plus

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EKSELANS KIT HOME WIFI and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

322004

Table of Contents