Pre-Selecting The Speed; Overload Clutch; Bit Stop; Maintenance And Cleaning - Parkside KH 3162 PNEUMATIC HAMMER DRILL Operation And Safety Notes

Pre-selecting the Speed

L
With the wheel on the speed pre-selector
can pre-select the operating speed to your individual
requirements.
If a low speed has been pre-selected, the ON / OFF
switch is automatically restricted in the extent to
R
which it can be pulled back (due to the reduced
speed of rotation).
Recommended speed ranges (non-binding; if
necessary, you should determine the correct setting
by a practical test):
- High-speed: for hammer drilling in concrete or
stone and for chiselling
- Medium speed: for drilling into steel or wood
- Low speed: for screwing
Low speed / high speed:
j
Turn the wheel for speed pre-selection
The ON / OFF switch has a variable speed control.
R
j
By pressing the switch you can increase the
speed continuously.

Overload Clutch

L
For your safety the PEBH 1010 hammer drill is fitted
with an overload clutch. This ensures that the drive
is automatically interrupted if the drilling tool becomes
jammed, thereby considerably reducing the risks
when working. Nevertheless, you should always
ensure that you stand in a stable position, hold the
hammer drill tightly with both hands and always use
the additional handgrip
O

Bit Stop

L
With the help of the bit stop
drilling depth and therefore carry out accurate drilling.
j
Define the required drilling depth by moving the
bit stop .
P
Using the Device / Maintenance and Cleaning / Disposal
you
Y
.
Y
.
you can adjust the
P

Maintenance and Cleaning

L
J
Warning! Before carrying out any work on the
drill you should always remove the plug from
the socket!
J
No liquids must be allowed to enter the hammer
drill.
j
Clean the hammer drill regularly, preferably
always immediately after finishing your work.
j
Please use a dry cloth for cleaning the housing.
Under no circumstances should you use petrol,
solvent or cleaning agents which might attack
the plastic.
j
Clean the tool holder
To do so, pull the locking / unlocking cap
towards the rear and lever off the rubber dust
protection cap . Release the locking / unlock-
W
ing cap slowly. Caution! This is pre-stressed!
E
Clean the components with a brush and apply a
small amount of grease to them.

Disposal

L
The packaging is made entirely of recyclable
materials, which you may dispose of at local
recycling facilities.
Do not dispose of electrical appliances
in household waste.
In accordance with European Directive 2002 / 96 / EC
on used electrical and electronic appliances and its
implementation in national law, used power tools
must be collected separately and recycled in an
ecologically compatible manner.
Information on options for disposing of electrical
appliances after their useful life can be obtained
from your local or city council.
regularly.
Q
E
GB/IE 11