Selecting The Function With The Function Selector Switch; Switching On And Off; Selecting The Angle Of Rotation - Parkside KH 3162 PNEUMATIC HAMMER DRILL Operation And Safety Notes

Using the Device
Clamping the Tool
j
Hold the rear sleeve of the quick-action drill
chuck tightly and turn the front sleeve forcefully
until you hear a repeated clicking noise. The drill
chuck is now locked in place.
j
The lock can be released again by turning the
front sleeve in the opposite direction.
Using Assembly Tools for Screws and Nuts
j
Use an appropriate bit holder if you would like
to use screwdriver inserts / bits for screwing.
j
You should only use inserts / bits which fit the
screw head.
j
Turn the function selector switch
symbol .
Selecting the Function with the
L
Function Selector Switch
Note: The function must only be
changed when the device is switched
off, as otherwise it may be damaged.
Depending on the intended use, you can select
between four functions by turning the function
selector switch .
I
j
Turn the function selector switch
desired symbol locks into place next to the
arrow mark.
The functions are marked as follows:
Function
Drilling / screwing
Hammer drilling
Chiselling
Chisel position
adjustment
10 GB/IE
to the drill
I
so that the
I
Symbol
Adjusting the Chisel Position
This function makes chiselling work con-
siderably easier by the setting of individual
angle positions for the chisel. This enables
you to turn the tool for the chiselling work (see also
Fig. C, D) to the required position.
j
Turn the function selector switch
position .
j
Turn the tool in the tool holder
position.
j
For the chiselling work turn the function selector
switch to the position
I

Switching on and off

L
When operating the hammer drill you can choose
between temporary and permanent operation.
Use the temporary operation for small jobs and
permanent operation for long jobs.
Your desired setting is operated as follows:
Switching on temporary operation:
j
Press the ON / OFF switch
Switching off temporary operation:
j
Release the ON / OFF switch
Switching on permanent operation:
j
Press the ON / OFF switch
on position by means of the locking button
Switching off permanent operation:
j
Press the ON / OFF switch

Selecting the Angle of Rotation

L
Note: Use / adjustment of the clockwise / counter-
clockwise switch is only permitted with the device
U
standing still.
When switched to counter-clockwise rotation the
device automatically runs at a reduced speed.
to the
I
to the required
Q
.
.
R
.
R
and lock it in the
R
.
T
and release it again.
R