Safety; Safety Information Specific To This Device; Using The Device; Operation - Parkside KH 3162 PNEUMATIC HAMMER DRILL Operation And Safety Notes

Safety

L
Safety Information Specific
to this Device
J
For safety reasons this device may only be used
with the additional handgrip
J
When working with this device, hold it tightly
with both hands at all times. Ensure that you are
standing in a stable position.
J Caution: Please ensure that the ventilation slits
are not covered during operation. Do not insert
any objects into the ventilation slits.

Using the Device

L

Operation

L
Note the mains voltage! The voltage of the mains
socket must match that shown on the rating plate
on the device (Devices marked with 230 V~ can also
be operated at 220 V~).

Assembling the Additional Handgrip

L
For safety reasons this device may only be used
when the additional handgrip
(see also Fig. D, E).
j
Attach the additional handgrip
neck and turn it in an anticlockwise direction
until it is tight.

Inserting / Removing Tools

L
Inserting a Tool
j
Before inserting the tool, apply a small amount
of grease to the tool holder
j
In order to insert the tool, pull the locking / un-
locking cap to the rear and insert the tool.
E
j
Release the locking / unlocking cap
locks the tool holder in place.
.
O
is correctly assembled
O
to the spindle
O
.
Q
. This
E
Safety / Using the Device
Pull the tool to ensure that it is firmly locked in
place. The tool has some radial play inherent in
the system.
Removing a Tool
j
In order to remove the tool, pull the locking /
unlocking cap to the rear.
E
quick action chuck for
L
round-shank drills
m Caution! Do not use the round-shank drill for
hammer drilling or chiselling work!
Inserting the RÖHM Quick-Action Drill Chuck
for Round-Shank Drills
j
To insert the additional drill chuck for round-
shank drills (see also Fig. A), pull the locking /
unlocking cap towards the rear and insert
E
the additional drill chuck.
j
Release the locking / unlocking cap
locks the tool holder in place. Pull the tool to
ensure that it is firmly locked in place.
Removing the RÖHM Quick-Action Drill Chuck
for Round-Shank Drills
j
In order to remove the additional drill chuck, pull
the locking / unlocking cap
and take out the additional drill chuck.
Inserting Tools
m Caution! Before making any modifications to
the device ensure that it is switched off and that the
mains plug has been removed from the socket.
The RÖHM quick-action drill chuck allows you to
change the tool quickly without any additional
implements.
Releasing the tool holder and inserting a tool
j
Hold the rear sleeve of the quick-action drill
chuck tightly and turn the front sleeve until it is
wide enough for the tool (e.g. round-shank drill)
to be inserted.
j
Then insert the tool.
. This
E
towards the rear
E
GB/IE 9