Putting The Transmitter Into Operation; Setting Up The Transmitter On A Flat Surface - Sennheiser SR 300 IEM G3 - 01-09 Instruction Manual

Putting the transmitter into operation

Mounting the rack
mount "ears"
Fitting the device feet
Connecting the
rod antenna
8
Putting the transmitter into operation
When using more than one transmitter, we recommend connecting remote
antennas and, if necessary, using Sennheiser antenna accessories. For more
information, visit the ew G3 product page at www.sennheiser.com.

Setting up the transmitter on a flat surface

Place the transmitter on a flat, horizontal surface. Please note that the device feet can leave
stains on delicate surfaces.
The rack mount "ears" are designed to help protect the operating elements from
damage or deformation, e.g. if the transmitter is dropped. Therefore, fasten the rack
mount "ears", even if you do not want to rack mount your transmitter.
To fasten the rack mount "ears"
Unscrew and remove the two recessed head screws (M4x8) on each side of the
transmitter (see left-hand diagram).
Secure the rack mount "ears"
removed recessed head screws (see right-hand diagram).
Do not fit the device feet when mounting the transmitter into a 19" rack.
Clean the base of the transmitter where you want to fix the device feet.
Fit the device feet to the four corners of the transmitter.
The supplied rod antenna
Connect the rod antenna
:
to the sides of the transmitter using the previously
is suitable for use in good reception conditions.
(see diagram on page 9).