The Extended Menu "Advanced Menu - Sennheiser SR 300 IEM Instruction Manual

Adjusting settings via the operating menu
Menu
Sensitivity
Mode
Easy Setup
Frequency Preset
Name
Equalizer
Auto Lock
Advanced
Exit
Advanced Menu
Tune
Sync Settings
RF Power
Warnings
LCD Contrast
Reset
IP-Address
Software Revision
Exit
Advanced Menu
Tune
Sync Settings
RF Power
Warnings
LCD Contrast
Reset
IP-Address
Software Revision
Exit
28
Activating/deactivating the automatic lock mode – "Auto Lock"
PEAK PEAK Menu
0 0
Equalizer
-10 -10
-20 -20 Auto Lock
-30 -30
Advanced
-40 -40
Inactive
AF AF
Call up "Auto Lock"
The lock mode prevents that the transmitter is accidentally switched off or programed during
operation. The lock mode icon
activated. For information on how to use the lock mode, refer to page 15.
Turn the jog dial to select the desired setting.
The extended menu
Setting the transmission frequencies and the frequency banks "U1" to "U6" –
"Tune"
When you have selected one of the system banks and then select the "Tune" menu,
the transmitter automatically switches to channel 1 of the frequency bank "U1". In
this case, "U1.1" briefly appears on the display panel.
Upon delivery, the channels of the frequency banks "U1" to "U6" are not assigned a
transmission frequency.
When you are in the "Tune" menu item, the RF signal is deactivated.
Via the "Tune" menu item, you can:
1. set a transmission frequency to be stored in the current channel of the selected frequency
bank ("U1" to "U6")
or
2. select a frequency bank ("U1" to "U6") and a channel and assign this channel a
transmission frequency.
Setting a transmission frequency for the current channel
Turn the jog dial until the "Tune" menu item appears.
Press the jog dial.
The frequency selection appears.
PEAK PEAK Auto Lock
0 0
-10 -10
Inactive
-20 -20
-30 -30
-40 -40
AF AF
Select the desired
setting
"Stored"
on the standard display indicates that the lock mode is
"Advanced Menu"
PEAK PEAK Auto Lock
0 0
-10 -10
Active
-20 -20 – 18 dB
-30 -30
-40 -40
AF AF
Store the setting