Sennheiser SKM 5200-II - ANNEXE 696 Instruction Manual page 19

The operating menu
By way of example of the "LOWCUT" menu, this section describes how to
use the operating
Display mode
SET/ON
MHz
MHz
After switch-on
After switch-on, the standard display is shown on the display panel.
Depending on the setting, the transmission frequency, the channel
number or the name of the radio microphone is displayed.
Displaying the menu settings in display mode
In display mode, and with the lock mode activated, you can display the
current menu settings one after the other (see "Overview of the operating
menu" on page 21). After a few seconds, the display returns to the
standard display. With the lock mode activated, the LC display is not
backlit.
18
SET
SET
MHz
SET
MHz
Current
low-cut-frequency
Selection mode
TUNE
SET
LOWCUT
Adjusting the
low-cut-frequency
STORED
SET
Setting mode
120
Hz
Current
low-cut-frequency
190
Hz
FLAT,
120 Hz, 190 Hz