25 to 110 MHz höchstens 0,5 MHz Abstand separated by 0.5 MHz maximum Senderleistung 1 W (7,75 V an 60 Q) bei 15 V Batteriespannung RF power 1 Watt (7,75 V at 60 Q) + 40° C Frequenzkonstanz (Temperatur - 10°...
Approx. 2 km using the shoulder strap must be set to the type of input den gewünschten Eingang geschaltet. )J2-Dipol am Empfänger in 3 m Höhe antenna at the transmitter a )J2 quired. ca.2 km, dipole at 3 m above...
Page 5
Nach Abnehmen des Batte- The screws are provided with a slot to riekastens ist am Sender der Umschal- which a coin will fit. The box is then Kocllolll"tromeol (1.55 Coctrol 10ol,omeol ter zugängig, mit dem der Sender easy detachable,...
Page 6
Gegenkopplung von T, auf T, HF-Leistungsverstärker Mit den of the control voltage is achieved T9, TlO, T11 an output power of 1 VV is beeinflussen. Die erforderliche Sym- Stufen T9, T,0, T11wird die Leistung auf means of transistor T5 and the zener achieved.
An den Aus- Connect the RF signal generator gang Meßempfängers wird test point A with a signal of 3.71 MHz Klirrfaktormeßgerät gelegt. and 50 mV. The output of the discrimi- nator (test points Band C) is linked Abgleich des ZF-Teils to an amperemeter with mid-zero indi- cation.
Page 8
90 scale divisions wird dann der Spitzen hub (75 kHz bzw. Durch Verdrehen des Eisenkerns von age which should be 7.6 to 8 V and can 15 kHz) eingestellt. Position HF (high frequency) be checked by means of the frequency L, wird die Frequenz richtig eingestellt.