Technical Specifications - FSA POWERBOX K-FORCE TEAM EDITION User Manual And Instructions

4. Power meter shows no function
Battery is low - change battery
Operating software is in an undefined state (the power meter has "crashed") - Turn off and then on by
removing and inserting the battery. If this is unsuccessful, contact an FSA Service center.
5. Power measurements are not plausible
The zero point has changed uncontrollably - during a ride: do a zero point adjustment by depowering.
6. Water intrusion into the battery compartment
battery cap has not been closed correctly - remove battery and let area dry, insert battery again and close
battery cap battery cap is damaged or worn - remove battery and let area dry, insert battery again and close
battery cap.

13. Technical Specifications

Power source: battery
Battery life: approximately 400 hours of active power measurement
Transmission standards: ANT+ Power Only Profile
Transmitted data:
Power,
Cadence
Accuracy: ±2%
Additional features:
Active thermal correction
Automatic zero-point adjustment
Calibration is independent of chainring selection
No magnet necessary for cadence measurement
Range of measurement and display:
Power: 10 - 2999 W
Torque: 0 - 250 Nm
Cadence: 30 - 250 RPM
Colors: black
LED signals:
Green blinking: power meter activated, ANT+ active for pairing with computer unit
Red blinking short: power meter error
Directly after activation:
3 x green: battery charged 60 - 100%
2 x green: battery charged 40 - 60%
1 x green: battery charged 20 - 40%
1 x red short: battery charged 10 - 20% (equates to "weak battery")
1 x red long (5 seconds): battery charged 0 - 10%
14. Copyright
Copyright 2024. All rights reserved. No part of this publication can be reproduced, copied, photographed,
translated, passed on, downloaded or saved on any kinds of storage media.