Wired Network Connection; Wireless Network Connection - Flashforge Guider 3 User Manual

Please proceed in the following order:
Click the settings button and [Calibration] on the touch screen.
•
Select the [Z-axis calibration] button.
•
Perform Z-axis calibration by following the prompts on the screen.
•
Select the [Sensor calibration] button.
•
Perform sensor calibration by following the prompts on the screen.
•
Network Connection

Wired Network Connection

First, plug the network cable into the network cable port on the back of the 3D printer.
Then click on the settings button and [Network] on the touch screen, select the wired
network and turn on the wired network switch. If Ethernet icon appears at the upper
right corner of the screen, it indicates that the network is successfully connected.

Wireless Network Connection

Click on the settings button and [Network] on the touch screen, select the wireless
network, and turn on the wireless network switch. Click to connect to the corresponding
wireless network and the corresponding prompt will appear on the screen after a
successful connection. If the Wireless icon appears at the upper right corner of the
screen, it indicates that the network is successfully connected.
9