Sennheiser EW 300 IEM Instruction Manual page 45

Selecting the frequency, channel number
SENSIT Adjusting the sensitvity (SR 300 IEM only)
To match the transmitter to the output level of the connected device (e.g.
mixing console), you can adjust the input sensitivity in 4 steps of 5 dB from
0 to -15 dB.
With the buttons you can directly switch between the factory-
/
preset frequencies (channel presets). The display starts flashing. Your
selection becomes effective immediately.
Press the SET button to acknowledge your selection. The display stops
flashing.
Note:
You can choose the content of the standard display i.e. whether the
frequency, the channel number or – with the SR 300 IEM – a name is
displayed (u "Selecting the content of the standard display"). The
devices are factory-preset to show the frequency setting as standard.
Select the "SENSIT" menu by pressing the
appears on the display; after a short pause the current input sensitivity
setting is displayed.
With the buttons you can now select a different setting. The
/
input sensitivity can be adjusted in 5-dB steps from 0 to -15 dB. The
new setting starts flashing on the display and becomes effective
immediately.
Press the SET button to return to the top menu level. The display then
switches back to the standard display.
SET button until "SENSIT"
47