Sennheiser EW 300 IEM Instruction Manual page 36

38
Mounting the rubber feet
To ensure that the transmitter cannot slip on the surface on which it is placed,
four self-adhesive soft rubber feet are supplied. These feet are stuck into the
recesses on the bottom side of the receiver. (N.B.: Do not use these feet if
rackmounting the transmitter).
Ensure that the recesses are clean and free from grease before fixing
the feet.
Attention!
Some furniture surfaces have been treated with varnish, polish or
synthetics which might cause stains when they come into contact with
other synthetics. Despite a thorough testing of the synthetics used by
us, we cannot rule out the possibility of discolouration, since we don't
know your furniture.
Connecting the antenna
The SR 300 IEM transmitter can be used with either a telescopic antenna
(supplied) or a remote antenna (available as an accessory).
The supplied telescopic antenna can be mounted quickly and easily to the
rear of the transmitter and is suitable for all applications where – good
transmission conditions provided – a wireless transmission system is to be
used without a large amount of installation work.
Connect the telescopic antenna to BNC socket
transmitter and pull the end cap to extend the antenna.
If the transmitter position is not the best antenna position for optimum
transmission, you can use a remote antenna (available as an accessory).
Connecting the mains unit
Insert the DC connector on the power supply output cable into socket
at the rear of the transmitter.
Pass the cable through the cable grip
at the rear of the
, as illustrated.