Synchronizing The Transmitter With The Receiver Frequency - Sennheiser EM 3731 Instructions For Use Manual

save
790.800
EV
M
H
z
sync
03.03
BANK
AF COM
esc
CH
save
digital audio
processing
sync
esc
sync
5cm
<
SKM 5200

Synchronizing the transmitter with the receiver frequency

Via its infra-red interface, the receiver can transfer the frequency and the
name to suitable transmitters (e.g. SK 5212, SKM 5200 or SKP 3000).
Note:
The transmitter must be from the same frequency range ("A" to "I",
see page 5) and be equipped with the same compander system (HDP,
see page 38) as the receiver!
Set the receiver to the desired receiving frequency (see "Setting the
receiving frequency" on page 28 and "Selecting a frequency bank and
a channel" on page 28) and enter the desired name (see "Entering a
name" on page 29).
Press the sync
digital audio
processing
The two blue LEDs in the infra-red interface (sync)
backlighting of the
sync
synchronization.
Position the transmitter's infra-red interface at a max. distance of 5 cm
in front of the infra-red interface (sync)
The transfer starts automatically. During the transfer, the two blue
LEDs in the infra-red interface (sync)
RF %
A B
the sync button
300 PEA
100 10
30
5
– After successful completion of the synchronization, the two blue
10
V 1
LEDs in the infra-red interface (sync)
the sync button
name are now also set on the transmitter and the transmission link
is ready for operation.
– If an error occurred during synchronization (e.g. the transmitter is
too far away from the receiver), the two blue LEDs in the infra-red
interface (sync)
red.
Note on the SKM 5200 hand-held transmitter:
The infra-red interface of the SKM 5200 hand-held transmitter is
located at the left-hand margin of the display. Position the
transmitter's infra-red interface precisely in front of the infra-red
interface (sync)
9
button .
9
sync button flashes red. The receiver is ready for
A
A
flash and the backlighting of
9
flashes green.
9
is backlit in green. The receiver's frequency and
A
stop flashing and the
A
of the receiver.
Using the receiver
A
flash and the
.
A
stop flashing and
9
sync button is backlit in
21