Synchronizing A Transmitter With The Receiver - Sennheiser EM 100 G3 Instruction Manual

Using the receiver
20
To switch the receiver to
Keep the STANDBY
the display panel.
The receiver switches to standby mode.
When in the operating menu, pressing the
cancel your entry (ESC function) and return you to the current stan-
dard display.
To completely switch the receiver off:
Disconnect the receiver from the mains by unplugging the mains unit
from the wall socket.

Synchronizing a transmitter with the receiver

You can synchronize a suitable transmitter of the ew 100 G3 series with
the receiver. During synchronization, the following parameters are trans-
ferred to the transmitter:
Setting
"Frequency Preset" Currently set frequency
"Name"
"Pilot Tone"
It is vital to observe the notes on frequency selection on page 42.
standby mode:
button pressed until "OFF" appears on
Transferred parameters
Freely selectable name currently set on the receiver
Current pilot tone setting of the receiver
("Inactive"/"Active")
STANDBY button will