Synchronizing A Transmitter With The Receiver; Deactivating The Lock Mode Temporarily - Sennheiser EM 2000 Instruction Manual

Synchronizing a transmitter with the receiver

You can synchronize a suitable transmitter of the 2000 series with the receiver. By default,
the following parameters are transferred to the transmitter during synchronization:
To transfer the parameters:
To cancel the transfer:

Deactivating the lock mode temporarily

You can activate or deactivate the automatic lock mode via the
(see page 25).
If the lock mode is activated, you have to temporarily deactivate it in order to be able to
operate the receiver:
The lock mode icon
B.Ch: 20.64 **2000**
PEAK
40 0
543.200
-10 MHz
30
-20
20
-30 SKM2000
EQ:
10
-40
P + 12dB
MUTE
RF AF
Setting Transferred parameter
"Frequency Preset" Currently set frequency
"Name" Freely selectable name currently set on the receiver
"Pilot Tone" Current pilot tone setting of the receiver ("Inactive"/"Active")
Via the "Sync Settings" submenu, you can adjust additional parameters to be trans-
ferred to the transmitters (see page 29). It is vital to observe the notes on frequency
selection on page 31.
Switch the transmitter and the receiver on.
Press the button
"Sync" appears on the display panel of the receiver.
Place the infra-red interface of the transmitter (see the instruction manual of the trans-
mitter) in front of the infra-red interface
The parameters are transferred to the transmitter. When the transfer is completed, " "
appears on the receiver's display panel. The receiver then switches back to the current
standard display.
Press the STANDBY button
" " appears on the display panel of the receiver. " " also appears if no suitable trans-
mitter was found.
Press the jog dial or the
"Locked" appears on the standard display.
Turn the jog dial.
"Unlock?" appears on the display panel.
Press the jog dial.
The lock mode is temporarily deactivated.
– When you are in the operating menu, the lock mode remains deactivated until
you exit the operating menu.
– When one of the standard displays is shown, the lock mode is automatically
activated after 10 seconds.
flashes prior to the lock mode being activated again.
on the receiver.
of the receiver.
on the receiver.
STANDBY button.
Using the receiver
"Auto Lock" menu item
15