Sennheiser EM 3731 Instructions For Use Manual page 31

B.Ch
U.01
776 866
UHF MHz
1.
790.800
MHz
save
DEV 790.800
M
H
z
sync
03.03
BANK
AF COM
esc
CH
The selected frequency bank and the selected channel are set. The
display changes to the selection mode of the operating menu.
Changing the receiving frequency for a selected channel in the
frequency bank "U"
Tune Each receiver has seven frequency banks. The frequency banks "1" to "6"
have up to 60 channels that are factory-preset to a receiving frequency
(see enclosed frequency tables). The frequency bank "U" (user bank) has
60 channels to store your selection of receiving frequencies that can be
freely selected in 5-kHz increments within the switching bandwidth. Via
the "Tune" menu, you can freely select the frequencies to be stored in the
frequency bank "U".
Change to the setting mode of the "B.Ch" menu and select the
790.
frequency bank "U" and one of the channels "01" to "60" whose
800
frequency you want to change and store (see "Selecting a frequency
MHz
bank and a channel" on page 28).
Note:
The receiving frequencies of the channels in the frequency banks "1" to
"6" cannot be changed. When you have selected one of the frequency
banks "1" to "6" and then select the "Tune" menu, the receiver
automatically switches to channel "01" of the frequency bank "U".
Change to the setting mode of the "Tune" menu and select the
B.Ch
receiving frequency you want to store (see "Setting the receiving
frequency" on page 28).
The selected receiving frequency is set and stored on the selected
channel of the frequency bank "U", i.e. the previously stored frequency
is overwritten. The display changes to the selection mode of the
operating menu.
Entering a name
Name Via the "Name" menu, you can enter a freely selectable name for the
receiver. The name can be displayed on the status display and can consist
of up to six characters such as:
letters (without pronounciation marks),
number from 0 to 9,
special characters and spaces.
Change to the setting mode of the "Name"
menu.
The first character of the name starts
flashing.
Select a different character by turning the jog dial
The selected character starts flashing.
Confirm the selected character by pressing the jog dial
digital audio
processing
The first character is accepted and stops flashing. The next character
sync
starts flashing.
Repeat the last two steps to enter the remaining characters.
After you have entered the six characters of the name, press the
8
button .
The name is stored. The display changes to the selection mode of the
operating menu.
In order that the name is displayed on the status display, you may have to
change the contents of status display (see "Selecting the status display"
on page 36).
The operating menu
+ , - | / 0 1 2 3 4 5 6
7 8 9 * ; < = > A A B
EL
C D E F G H I J K L M N
OPQRSTUVWXYZ
7
.
7
.
save
29