Sennheiser EM 100 G3 Instruction Manual page 13

Putting the receiver into operation
Fitting the
device feet
Stacking receivers
CAUTION!
12
To fasten the stacking elements
Unscrew and remove the two recessed head screws (M4x8) on each
side of the receiver (see left-hand diagram).
Secure the stacking elements
previously removed recessed head screws (see right-hand diagram).
If you want to stack receivers (see next section), only fit the device
feet to the base of the lowermost receiver.
Do not fit the device feet when mounting the receiver into a
19" rack.
Clean the base of the receiver where you want to fix the device feet.
Fit the device feet to the four corners of the receiver as shown.
Place the receiver on a flat, horizontal surface.
You can stack several receivers on top of each other.
Danger of injury due to toppling receiver stacks!
High receiver stacks can easily topple over.
Place the stack on an absolutely flat surface.
Secure the stack against toppling over.
Fasten the stacking elements as described in the previous section.
Stack the receivers so that the recesses of the stacking elements
completely engage with each other.
:
to the sides of the receiver using the