Using the receiver
To establish a transmission link, proceed as follows:
1. Switch the receiver on (see next section).
2. Switch the transmitter on (see the instruction manual of the transmitter).
The transmission link is established and the receiver's RF level display
"RF" reacts.
It is vital to observe the notes on frequency selection on page 42.
If you cannot establish a transmission link between transmitter and
receiver:
Make sure that transmitter and receiver are set to the same frequency
bank and to the same channel.
Read the chapter "Synchronizing transmitters with receivers" on
page 42 and, if necessary, the chapter "If a problem occurs ..." on
page 47.
Switching the receiver on/off
To switch the receiver on:
Briefly press the
The receiver switches on and the
dard display appears.
PEAK
20.12
ew100 G3
40
0
533.875
-10
MHz
25
-20
10
-30
P
RF
AF
SET
STANDBY
button
.
"Receiver
Using the receiver
Parameters" stan-
19