Switching The Conference System On/Off - Sennheiser ADN Instruction Manual

Putting the conference system into operation
Running the software on a
separate Windows PC
IN –– AUDIO –– OUT
PORT II PORT I
2x 52.8V 1.75A
1
20
To run the "Conference Manager" software on a separate Windows PC, the PC must
meet the system requirements listed on page 50.
Use a network cable (Cat5) to connect the Ethernet socket
unit to the network interface of your PC.
You can also connect the PC and the central unit using a switch or similar.
100-240V~
50/60Hz 240W
B
Install the "Conference Manager" software supplied on the CD ROM on your
connected PC (see page 51).
Configure the network as described in the chapter "Preparing the Windows
version of the software for use" on page 50.

Switching the conference system on/off

To switch the conference system on:
Set the on/off switch
The central unit switches on and its display panel lights up.
To switch the conference system off:
If you have made changes to a configuration using the "Conference
Manager" software, you have to save these changes before switching the
central unit off (see page 69). All other settings of the central unit are
automatically saved.
Set the on/off switch
The central unit is switched off completely.
1
to position "I".
1
to position "0".
B
of the central