Victorian Plumbing AREZZO Fitting Instructions Manual

Two hole bath/basin mixer tap

Advertisement

Quick Links

Two Hole Bath/Basin
Mixer Tap
Fitting Instructions
Please follow them carefully and
leave this manual with end user
V3.02.24

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AREZZO and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Victorian Plumbing AREZZO

  • Page 1 Two Hole Bath/Basin Mixer Tap Fitting Instructions Please follow them carefully and leave this manual with end user V3.02.24...
  • Page 2: Before You Begin

    Before you begin: We recommend that this product is installed by a qualified tradesperson, Victorian Plumbing Ltd. accept no liability for products incorrectly installed, or where the correct testing procedures have not been adhered to, thus resulting in the escape of water and consequential damage.
  • Page 3: Installation

    Installation: Determine the fixing position for the valve and make a recess in the wall to house the valve (1). The depth of the recess should be 80mm to 100mm within the finished wall surface to fit the flanges correctly. Insert the valve (1) into the wall recess, then mark the fixing points with the mounting lugs that are cast on the valve body.
  • Page 4 Diagram: Cold V3.02.24...
  • Page 5 Diagrams are for illustration purposes only. Your Mixer Tap may superficially differ from this drawing however the installation guide steps still apply. V3.02.24...
  • Page 6: Plumbing Connections

    Operation: Flow Control Cold Plumbing Connections Cold Basin/Bath Aftercare: Always clean the surface of mixer tap to keep it bright. Attention: please do not use inappropriate tools such as sharp brushes, rough sponges, scouring pads or corrosive detergent to clean the mixer tap. Please clean the mixer tap by wet cloth and soapy water after each time of usage.
  • Page 7: Troubleshooting

    Troubleshooting FAULT POSSIBLE CAUSE Hot and cold supplies have been plumbed the wrong direction. Tap only runs hot or cold after installation Faulty thermostat. Insufficient water pressure. Check the hot water supply temperature. Tap does not run hot enough Blockage in the hot supply. Check and clean non-return valves.
  • Page 8 www.victorianplumbing.co.uk V3.02.24...

Table of Contents