Subscribe to Our Youtube Channel
Related Manuals for activeshop Marathon Multi 600
Summary of Contents for activeshop Marathon Multi 600
- Page 1 Instructions for use Marathon Multi 600 milling machine Importer: ACTIVESHOP Ltd. 8b Graniczna St., building DC2A 54-610 Wroclaw, Poland www.activeshop.com.pl Rev. A/04/2024...
- Page 2 Before using for the first time, carefully read the accompanying instructions. Do not throw away the instructions. Before commissioning, the device must stand min. 3 hours at room temperature. Extremely strong and durable A great and reliable router that will work all day long for all kinds of tasks related to prosthetic work. It will also work well for wood carving and jewelry processing.
- Page 3 The plug of the foot control switch cable must be well connected to the back of the device body. Make sure that the cutter you want to use was not bent, asymmetrical, or damaged. Always use standard cutters. Attention!!! Unlocking the handle during operation will damage the machine. Replacing cutters while the engine is running will damage the clutch.
- Page 4 Installation of the device Installation and electrical connection Fig 2 Fig 1 Tighten the screws located at the base of the head (14) at the same time tightening the elbow control module (8). (Fig. 1) Installed base blocking the knee control. The cable from the head (20) should be connected to the input (10).
- Page 5 Fig 3 Fig 5 Fig 4 Knee control. Position the control unit in a suitable place for you in the case of knee control as in Figure 3 and secure with screws. Recommended height from the ground: 520~550 mm or 530~580 mm. Connect the head cable to the motor connector at the rear of the head in the correct direction and tighten the plug firmly.
- Page 6 Components of the device Head base, Speed control, Foot/manual control, Rotation selection-right/left, Auto speed memory, Speed display, On/Off Switch, Knee control, Support, Head connection, Foot control connection, Fuse, Power cable, Head stand, Foot control, Safety pin for transportation, Jaw Tip, Twist lock, Head, Communication cable connecting the base to the handpiece,...
- Page 7 Before starting the head, you should: Turn off the head with the 0/I button (7), each time you connect the head or foot control. When the manual/leg control LED is off (3), the speed can be adjusted with the knob (2). When the manual/leg control diode is on (3), the speed can be adjusted with the foot control (15) or knee control (8).
- Page 8 Cruise control mode When the foot switch is used, the Auto Cruise function allows you to maintain speed after removing pressure from the foot switch. Activate by pressing the Auto Cruise⑤ switch and holding down the foot switch with equal pressure for 2 seconds. Deactivate by pressing the foot switch. NOTE!!! When performing the procedure, wear a mask and safety goggles.
-
Page 9: Error Codes
Engine vibrates or suddenly stopped running Automatic error Interface control detection defective Memory of the controller is damaged Internal circuit error The control system is defective In case of any of the above-mentioned errors when using the device, we recommend contacting Activeshop service. -
Page 10: Security Measures
At the end of their useful life, as well as old appliances contain full-value recyclable components, so they should be handed over for recycling. Therefore, they should be handed over to appropriate collection points, as well as they can also be handed over to ACTIVESHOP Ltd. -
Page 11: Storage And Transport
STORAGE AND TRANSPORT The device should be transported at a temperature in the range of (-) 20 °C to (+) 50 °C only in its original packaging. Store the device in a well-ventilated area with a relative humidity of no more than 75%.
Need help?
Do you have a question about the Marathon Multi 600 and is the answer not in the manual?
Questions and answers