Bluetooth Device - Sony STR-DN1030 Operating Instructions Manual

Pairing the receiver with a

Bluetooth device

Pairing is an operation where Bluetooth
devices register with each other beforehand.
Use the procedure below to pair the receiver
with your Bluetooth device. Once a pairing
operation is performed, it does not need to be
performed again. If pairing is already
completed, proceed to "Playing music of a
Bluetooth device" (page 83).
BLUETOOTH
1
Place the Bluetooth device
within 1 meter (3.3 feet) from
this receiver.
2
Press BLUETOOTH to select
Bluetooth function.
3
Hold down BLUETOOTH for 2
seconds to activate the pairing
mode of the receiver.
"Pairing ready" appears on the TV screen
and "BLUETOOTH" flashes quickly on
the display panel. Perform step 4 within 5
minutes, otherwise pairing will be
canceled. In this case, repeat this step.
4
Perform pairing on the
Bluetooth device to detect this
receiver.
For details, refer to the operating
instructions of your Bluetooth device.
A list of detected devices may appears on
the Bluetooth device display depending
on the type of Bluetooth device. This
receiver is displayed as "STR-DN1030".
US
82
Note
When establishing a connection with this
receiver, select the audio profile (A2DP,
AVRCP) at the Bluetooth device. If the
Bluetooth device does not support the AVRCP
profile, you cannot perform playback or other
operations with this receiver (page 81).
5
Select "STR-DN1030" on the
Bluetooth device display.
If "STR-DN1030" is not displayed,
repeat from step 1.
6
If passkey* is required on the
display of the Bluetooth device,
enter "0000".
7
Once pairing is completed,
connect this receiver with the
Bluetooth device.
Depending on the device, connection is
automatically made along with the
pairing. Once the connection is
established, the device name appears on
the TV screen and "BLUETOOTH"
lights up on the display panel.
* Passkey may be called "Passcode", "PIN code",
"PIN number" or "Password".
Notes
• If pairing is not successful, "Cancel" appears on
the TV screen. Repeat steps 1 to 6.
• The receiver only supports numerical passkey up to
4 digits.
• You can pair up to 9 Bluetooth devices with this
receiver. If 10th Bluetooth device is paired, the
least recently connected device will be replaced by
the new one.
• To pair with other Bluetooth devices, repeats steps
1 to 6.
• To delete all pairing information, see "Clear
History" (page 101).
To cancel pairing operation
Hold down BLUETOOTH after step 3.
"Cancel" appears on the TV screen.