Using The Sound Optimizer Function; Using The Advanced Auto Volume Function - Sony STR-DN1030 Operating Instructions Manual

Using the Sound
Optimizer function
The Sound Optimizer lets you enjoy clear and
dynamic sound at low volume levels. It
automatically calibrates the sound which
cannot be heard well when you turn down the
volume level. After Auto Calibration is
performed, the sound level is optimized to suit
your environment.
Press SOUND OPTIMIZER to select
"S. OPT. ON".
The Sound Optimizer function is activated.
The Sound Optimizer is set to on and off as
you press SOUND OPTIMIZER.
Note
This function does not work when "A. DIRECT" is
being used.
US
64
Using the Advanced Auto
Volume function
This receiver can adjust the volume
automatically depending on the input signal or
content from the connected equipment.
This function is useful, for example, when the
sound of a commercial is louder than the TV
programs.
SOUND
OPTIMIZER
Press AMP, then press AUTO VOL
to select "A. VOL ON".
The Advanced Auto Volume function is set to
on and off as you press AUTO VOL.
Notes
• Be sure to reduce the volume level before you turn
on/off this function.
• As this function is available only when Dolby
Digital, DTS or Linear PCM signals are input, the
sound may suddenly increase when you switch to
other formats.
• This function does not work in the following cases.
– Linear PCM signals with a sampling frequency
– Dolby Digital Plus, Dolby TrueHD, DTS 96/24,
AMP
of more than 48 kHz are being received.
DTS-HD Master Audio, or DTS-HD High
Resolution Audio signals are being received.
AUTO
VOL