Related Manuals for FlySky FS-G4P1-BS
Summary of Contents for FlySky FS-G4P1-BS
- Page 1 FS-G4P1-BS&FS-R4D-ESC-BS USER MANUAL USER MANUAL Digital Proportional Radio Control System Copyright ©2023 Flysky Technology Co., Ltd.
- Page 2 If you encounter any problems during using, please refer to this manual first. If the problem is still not resolved, please contact the local dealer directly or contact the customer service staff via the website below: http://www.flysky-cn.com...
-
Page 3: Table Of Contents
6.7 ESC Running Mode ......................16 6.8 ESC Battery Type ......................16 6.9 Failsafe ..........................16 6.10 Troubleshootings ......................17 7. Product Specifications ............18 7.1 Transmitter Specifications( FS-G4P1-BS) ................18 7.2 Receiver Specifications (FS-R4D-ESC-BS) ................19 8. Package Contents ..............20 9. Certifications ................21 9.1 DoC Declaration .......................21 9.2 CE Warning ........................21... -
Page 4: Safety
Safety Safety Symbols Pay close attention to the following symbols and their meanings. Failure to follow these warnings could cause damage, injury or death. Danger • Not following these instructions may lead to serious injuries or death� Warning • Not following these instructions may lead to major injuries� Attention •... -
Page 5: Introduction
FS-R4D-ESC-BS 2�Introduction The FS-G4P1-BS is a simplifed 4-channel transmitter that adopts the 2.4GHz 2A-BS Automatic Frequency Hopping Digital System which is independently developed by the FLYSKY. Its appearance shows speed, passion and power with the elements of sports car. It can set ESC parameters through the transmitter. This transmitter also has a Beginner Mode for entry players to use. - Page 6 [16] [18] [17] Steering Wheel Angle, the maximum rotation of the [1] Panel Flip Cover [10] steering wheel is 35 degrees from center to left or right (CH1). [2] ST.REV, Steering Channel Reverse Button [11] Toggle Switch, to set the related function of ESC. [3] R.LED, Power Indicator [12] TH.TRIM, to adjust the trim of throttle channel.
-
Page 7: Receiver Overview
FS-G4P1-BS& Digital Proportional Radio Control System FS-R4D-ESC-BS 2�2 Receiver Overview [13] [12] [11] [10] [14] [15] [16] [17] [18] [19] [20] [21] [22] [23] [24] [1] CH1 [9] Roof Light Interface [17] - (Motor Cable Cathode) [2] CH3 [10] - (Car Light Interface Cathode) -
Page 8: Getting Started
3� Getting Started Before operation, install the battery and connect the system as instructed below. Transmitter Battery Installation Danger • Only use specified battery (X4 AA batteries)� Danger • Do not open, disassemble, or attempt to repair the battery� Danger •... -
Page 9: Instructions
• Applicable to FS-G4P1-BS transmitter and FS-R4D-ESC-BS receiver� Different receivers have different bind procedures� For more information, visit the FLYSKY website for manuals and other related information� • Product information is updated regularly, please visit our website for more information�... -
Page 10: Stick Calibration
4�4 Stick Calibration This function is used to set the neutral position for throttle trigger and steering wheel. Every transmitter is calibrated before leaving the factory, however if recalibration is required, please follow these steps: Turn and hold the steering wheel clockwise to the max travel point and push the throttle trigger forwards as far as possible, and at the same time turn on the transmitter, the transmitter will be in calibration mode. -
Page 11: System Functions
FS-G4P1-BS& Digital Proportional Radio Control System FS-R4D-ESC-BS 5�System Functions This section focuses on the functions and how to use them. 5�1 Channel Descriptions The transmitter outputs a total of 4 channels, which are assigned as follows, as well as the functions. -
Page 12: D/R
5�4 D/R The ST. D/R switch is used for servo travel adjustment, and can also adjust the D/R for CH2 (throttle), CH3 and CH4 servo travel adjustment as multiplexing mode, see [5.5 Mode Switch] for multiplex switching mode; Adjustment range: 0-120%(the default is 100%), the step is 5%. ST.D / R +: Increase servo travel amount. -
Page 13: Beginner Mode
FS-G4P1-BS& Digital Proportional Radio Control System FS-R4D-ESC-BS 5�7 Beginner Mode Beginner mode is designed for people who is new to the hobby. In this mode, the throttle will be limited to output 50 percent, The channel range defaults to 1250~1500~1750us. -
Page 14: Reset Data
slide switch to the right position, then the running mode is set to FWD/REV. Battery Type There are LiPo and NiMH cells which can be set. It can be set according to the actual use. Setup: Toggle the No. 2 slide switch to the left position, then the battery type is set to Lipo. Toggle the No. 2 slide switch to the right position, then the battery type is set to NiMH. -
Page 15: Fs-R4D-Esc-Bs Function Instructions
FS-G4P1-BS& Digital Proportional Radio Control System FS-R4D-ESC-BS 6. FS-R4D-ESC-BS Function Instructions This chapter mainly introduces the precautions for using the FS-R4D-ESC-BS 2-in-1 receiver and the settings of the related function. 6�1 Attentions • Make sure the product is installed and calibrated correctly, failure to do so may result in serious injury. -
Page 16: Car Light Control
The receiver supports the overheating protection function. Overheating protection: When the receiver enters the overheating protection state in case of the high internal temperature of the ESC, CH2 motor channel has no output. The others output normally, and all the car lights flash fast for prompt. - Page 17 FS-G4P1-BS& Digital Proportional Radio Control System FS-R4D-ESC-BS In Case of Two-channel Control Mode Switch Method: Same as the four-channel control mode. • Normal Mode: For ① : Turn the steering wheel counterclockwise, left turn signal light flashes slowly; Turn the steering wheel clockwise, right turn signal light flashes slowly.
-
Page 18: Esc Function Instructions
The steering CH1 channel and throttle CH2 channel for car light control are capable of automatic neutral position identifying, after the trim is turned, the receiver should be powered again to recognize the neutral positions of these two channels automatically. The no-load output voltage of the car light interface is 6V, and the internal 100 Ω... -
Page 19: Esc Drag Brake Force
FS-G4P1-BS& Digital Proportional Radio Control System FS-R4D-ESC-BS 6�6 ESC Drag Brake Force The receiver supports the function of setting drag brake force at the transmitter side. It can be set to four levels: 0, 50%, 75% or 100%. The default drag brake force is 0. Refer to [5.8 ESC Parameters Setting] for details. -
Page 20: Troubleshootings
6�10 Troubleshootings Trouble(s) Possible Causes Solution(s) The motor cannot start 1. The ESC has no working voltage. 1. Check whether there is any connection problem and the LEDs are not on between the battery and ESC and whether there is 2. -
Page 21: Product Specifications
FS-G4P1-BS& Digital Proportional Radio Control System FS-R4D-ESC-BS 7. Product Specifications This section contains FS-G4P1-BS transmitter and FS-R4D-ESC-BS receiver specifications. 7�1 Transmitter Specifications( FS-G4P1-BS) Product Model FS-G4P1-BS Compatible Receivers FS-R4D-ESC-BS, FS-R4A3-BS Channels Model Type Car, Boat 2.4GHz ISM Maximum Power < 20dBm (e.i.r.p.) （EU）... -
Page 22: Receiver Specifications (Fs-R4D-Esc-Bs)
7�2 Receiver Specifications (FS-R4D-ESC-BS) Product Model FS-R4D-ESC-BS Compatible Transmitters FS-G4P1-BS, FS-MG41-BS Applicable Motors 540, 390, 370 or 280 Brushed Motor Main Applications 1:10 Crawler Car, Short-course Truck or Truck LiPo/NiMH Cells 2-3 LiPos or 5-7 NiMH cells Continuous / Peak Current... -
Page 23: Package Contents
FS-G4P1-BS& Digital Proportional Radio Control System FS-R4D-ESC-BS 8� Package Contents Transmitter*1(FS-G4P1-BS) Receiver*1(FS-R4D-ESC-BS) -
Page 24: Certifications
9. Certifications 9�1 DoC Declaration Hereby, [Flysky Technology Co., Ltd.] declares that the Radio Equipment [FS-G4P1-BS&FS-R4D-ESC-BS] are in compliance with RED 2014/53/EU. The full text of the EU DoC is available at the following internet address: www.flyskytech.com/info_detail/10.html 9�2 CE Warning The antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other transmitter. -
Page 25: Environmentally Friendly Disposal
FS-G4P1-BS& Digital Proportional Radio Control System FS-R4D-ESC-BS and installers must be provided with antenna installation instructions and transmitter operating conditions for satisfying RF exposure compliance. 2. Move all your channels to the desired position. 3. Select [All channels] and then [Yes] in the confirmation box. - Page 26 Copyright ©2023 Flysky Technology Co., Ltd. Release date: 2023-12-25 FCC ID： N4ZG4P00 FCC ID: 2A2UNR4DESC01 Manufacturer: ShenZhen FLYSKY Technology Co., Ltd. Address: 16F, Huafeng Building, No. 6006 Shennan Road, Futian District, Shenzhen, Guangdong, China...