Creating A Sata Raid Set In Bios; Creating A Raid Set - Asus Z13PE-D16 Manual

5.2

Creating a SATA RAID set in BIOS

You must set the RAID item in the BIOS Setup before you can create a RAID set from SATA
hard disk drives attached to the SATA connectors supported by Intel
To do this:
1. Enter the BIOS Setup during POST.
Refer to Chapter 4 for details on entering and navigating through the BIOS Setup.
2. Go to Platform Configuration > PCH Configuration > PCH Storage Configuration
> Controller SATA and RST Configuration.
3. Set SATA Mode Selection to [RAID].
4. Press <F10> to save your changes and exit the BIOS Setup, then enter the BIOS
Setup again..
5.2.1

Creating a RAID set

1. Go to Advanced > Intel(R) Virtual RAID on CPU to display the Intel
controller menu.
®
2. From the Intel
select Create RAID Volume and press <Enter>.
3. When the Name item is selected, enter a name for the RAID set and press <Enter>.
4. When the RAID Level item is selected, press <Enter> to select the RAID level to
create, and then press <Enter>.
5. Under Select Disks, press <Enter> and select X for the disks you want to include in
the RAID set.
ASUS Z13PE-D16
VROC SATA controller menu, select All Intel VMD Controllers, then
®
C741 chipset.
®
VROC SATA
5-3