Table of Contents
Advertisement
2.
Remove the bottom cover (see
3.
Remove the battery (see
4.
Remove the right speaker (see
Remove the fingerprint reader board:
1.
Remove the Phillips M2.0 × 2.5 screw (1) that secures the fingerprint reader bracket to the computer,
and then remove the bracket (2).
2.
Disconnect the cable from the ZIF connector (3) on the fingerprint reader board.
3.
Remove the fingerprint reader board (4) from the computer.
To install the fingerprint reader board, reverse this procedure.
RTC battery
To remove the RTC battery, use this procedure and illustration.
Table 6-3
RTC battery description and part number
Description
RTC battery (CR1620)
Before removing the RTC battery, follow these steps:
1.
Prepare the computer for disassembly (see
2.
Remove the bottom cover (see
3.
Remove the battery (see
Remove the RTC battery:
50
Chapter 6 Removal and replacement procedures for authorized service provider parts
Bottom cover on page
Battery on page
48).
Speakers on page
Preparation for disassembly on page
Bottom cover on page
Battery on page
48).
37).
45).
37).
Spare part number
N93638-001
37).
Advertisement
Table of Contents
