Troubleshooting; Transportation, Storage And Disposal - Husqvarna RIGG 900 C Operator's Manual

Table of Contents

Advertisement

Available languages

Available languages

To reset the product after an operation
failure
1. Move the product down to the ground or onto a
pallet.
Troubleshooting of the remote control
Problem
The LED is red.
The LED slowly
flashes red 3 times.
The LED quickly
flashes red.
Transportation
WARNING:
transportation. The product is heavy and can
cause injury or damage if it falls or moves
during transportation.
CAUTION:
behind a vehicle.
Make sure that the power supply is disconnected
before transportation.
For transportation, lift the product to move it or put
the product on a vehicle.
Do not lift a damaged product. Make sure that the
lifting eyes are correctly installed and not damaged.
Always use the slowest speed when you lift the
product.
The cables on the lifting equipment must have
tension before you lift the product from the ground.
Do not walk or stay below or near a lifted product.
Keep bystanders away from the work area.
Make sure that you can see the product and the
work area when you lift the product.
Put protection on the product during transportation.
The protection keeps natural elements, for example
rain and snow, away from the product.
16

Troubleshooting

Cause
The voltage in the batteries is low.
The batteries are empty.
The output in the receiver is not in operation
and there is no signal from the receiver.

Transportation, storage and disposal

Be careful during
Do not tow the product
2. Set the ON/OFF switch to OFF.
3. Push the OFF button on the remote control.
4. Wait 15 seconds and then set the ON/OFF switch to
ON and start the remote control.
Solution
Replace the batteries. Refer to
the batteries in the remote control on page
15 .
Replace the batteries. Refer to
the batteries in the remote control on page
15 .
Do a pairing operation. Refer to
ing operation of the remote control and the
product on page 12 .
To lift the product
WARNING:
applicable lifting equipment.
Attach the lifting equipment to the 4 lifting points of
the product.
To replace
To replace
To do a pair-
Only lift the product with
2157 - 001 - 07.03.2024

Advertisement

Table of Contents
loading

This manual is also suitable for:

970 69 07-01

Table of Contents