Troubleshooting - Husqvarna PG 830 Propane Operator's Manual

Problem
The product does not
start.
The engine does not
start.
The product does
not start immediately
when you turn the
main switch to ON.
The engine starts but
stops after a short
time.
The engine is on but
the grinder does not
start.
The engine stops.
The product does not
operate smoothly.
The product gives a
static electricity dis-
charge.
2023 - 003 - 04.04.2023

Troubleshooting

Cause
The battery is not charged.
The main switch is OFF position.
The emergency stop button is engaged.
The propane tank is empty.
The propane tank valve is closed.
The ignition is damaged.
The fuse is damaged.
The battery is not charged.
The control panel is damaged or does not
work correctly.
The propane tank is almost empty.
If the symbol check engine and carbon mon-
oxide values come on and the carbon mon-
oxide detector gives sounds, the carbon
monoxide values are higher than permitted
levels.
The belt is broken.
The clutch disengages.
If the symbol check engine and carbon mon-
oxide values come on and the carbon mon-
oxide detector gives sounds, the carbon
monoxide values are higher than permitted
levels.
The product is not grounded correctly.
Water has entered the control panel.
The product is not grounded correctly.
The control panel is damaged or does not
work correctly.
Solution
Charge the battery.
Turn the main switch to ON position.
Turn the emergency stop button on the con-
trol panel control clockwise to disengage.
Fill or replace the propane tank.
Turn the propane tank valve to open the pro-
pane tank.
Speak to an approved service agent.
Examine the fuse on the engine. If the fuse is
damaged, replace the fuse.
Charge the battery.
Speak to an approved service agent.
Fill or replace the propane tank.
Make sure that the work area has good air-
flow.
If the belt is broken, let a service center re-
place it.
Turn one of the grinding discs by hand. If all
grinding discs rotate together, the belt is not
damaged. If one grinding disc rotates freely,
then the belt is broken.
Speak to an approved service agent.
Make sure that the work area has good air-
flow.
Turn the main switch to OFF and speak to an
approved service agent.
Speak to an approved service agent.
25