Installation - Husqvarna RIGG 900 C Operator's Manual

7. Install the 6 clamps at the necessary height on the
steel wire ropes. The clamps engage the limit switch
on the EBE 900 V shot blaster.
To adjust the drive wheels to the
diameter of the storage tank
• If the diameter of the storage tank is larger than 25
m, set the drive wheels in the straight position.
Introduction
WARNING:
safety chapter before you install the product.
To install the product on a storage tank
1. Assemble the product and adjust the support
To assemble the product on page
wheels. Refer to
8 .
2157 - 001 - 07.03.2024

Installation

Read and understand the
• If the diameter of the storage tank is 15–25 m, set
the drive wheels in the middle position.
• If the diameter of the storage tank is smaller than
15 m, set the drive wheels in the maximum turned
position.
2. Attach the end (A) of the safety rope to the center of
the roof on the storage tank.
B C
A
C
9