Technical Information - Electrolux GA60SLI221 User Manual

92
Problem
Dry water drop
stains on glasses
and dishes.
The dishes are wet.
The dishes are wet
and matt.
Activating the rinse aid
dispenser with the multitab
function activated
1. Press the on/off button to activate the
appliance.
2. Open the menu option.
3. Go to Settings .

TECHNICAL INFORMATION

Dimensions
Electrical connection
Water supply pressure
Water supply
Capacity
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
2) If the hot water comes from alternative sources of energy, (e.g. solar panels, aeolian energy),
use the hot water supply to decrease energy consumption.
Possible cause
The quantity of detergent
was too much.
The released quantity of
rinse aid was not sufficient .
The quality of the detergent
can be the cause.
• The programme had no
drying phase.
• The programme had a low
temperature drying phase.
The rinse aid dispenser is
empty.
The quality of the rinse aid
can be the cause.
The quality of the combi de-
tergent tablets can be the
cause.
Width / Height / Depth (mm)
Refer to the rating plate.
Voltage
Frequency
Min. / max. (bar / MPa)
1)
Cold water or hot water
Place settings
Possible solution
Make sure that you add the
correct quantity of detergent
in the dispenser before you
start a programme.
Increase the released quantity
of rinse aid.
Try a different brand of deter-
gent.
For better drying results, keep
the door ajar for some mi-
nutes.
Make sure that there is rinse
aid in the rinse aid dispenser.
Try a different brand of rinse
aid.
• Try a different brand of
combi detergent tablets.
• Activate the rinse aid dis-
penser and use the rinse
aid together with the combi
detergent tablets.
4. Press OK to open the submenu.
5. Go to Rinse aid and activate the rinse
aid dispenser.
6. Press OK to confirm.
7. Press the display touchpad to close the
menu option.
596 / 818 - 898 / 575
(0.5 / 0.05 ) / (8 / 0.8 )
2)
220-240 V
50 Hz
max. 60 °C
12