Technical Information - Electrolux GA60LI221 User Manual

Problem
Dry water drop
stains on glasses
and dishes.
The dishes are wet.
The dishes are wet
and matt.
Activating the rinse aid
dispenser with the multitab
function activated
1. Press the on/off button to activate the
appliance.
2. Make sure that the appliance is in set-
ting mode. Refer to 'SETTING AND
STARTING A PROGRAMME'.
3. Press and hold buttons (8) and (9) at
the same time until the programme indi-
cators above buttons (8), (9) and (10)
flash.
4. Press button (9) .
• The programme indicators above
buttons (8) and (10) go off.

TECHNICAL INFORMATION

Dimensions
Electrical connection
Possible cause
The quantity of detergent
was too much.
The released quantity of
rinse aid was not sufficient .
The quality of the detergent
can be the cause.
• The programme had no
drying phase.
• The programme had a low
temperature drying phase.
The rinse aid dispenser is
empty.
The quality of the rinse aid
can be the cause.
The quality of the combi de-
tergent tablets can be the
cause.
Width / Height / Depth (mm)
Refer to the rating plate.
Voltage
Frequency
Possible solution
Make sure that you add the
correct quantity of detergent
in the dispenser before you
start a programme.
Increase the released quantity
of rinse aid.
Try a different brand of deter-
gent.
For better drying results, keep
the door ajar for some mi-
nutes.
Make sure that there is rinse
aid in the rinse aid dispenser.
Try a different brand of rinse
aid.
• Try a different brand of
combi detergent tablets.
• Activate the rinse aid dis-
penser and use the rinse
aid together with the combi
detergent tablets.
• The programme indicator above but-
ton (9) continues to flash.
• The display shows the setting of the
rinse aid dispenser.
5. Press button (9) to change the setting.
6. Deactivate the appliance to confirm.
7. Adjust the released quantity of rinse aid.
8. Fill the rinse aid dispenser.
596 / 818 - 898 / 575
ENGLISH 83
Off
On
220-240 V
50 Hz