Solid-State Drive Board - HP 250R G9 Maintenance And Service Manual

2. Press down on the module (3) until the side retention clips snap into place.

Solid-state drive board

To remove the solid-state drive board, use this procedure and illustration.
Table 5-6 Solid-state drive board descriptions and part numbers
Description
Solid-state drive board
Solid-state drive board cable
Before removing the solid-state drive board, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Remove the battery (see
4. Remove the solid-state drive (see
Remove the solid-state drive board:
1. Disconnect the cable from the ZIF connector (1) on the solid-state drive board.
2. Remove the three Phillips M2.0 × 2.8 screws (2) that secure the board to the computer.
Preparation for disassembly on page
Bottom cover on page
Battery on page 32).
Solid-state drive on page
31).
36).
Solid-state drive board
Spare part number
L52026-001
L52025-001
31).
39