Operation - Makita DBN900 Instruction Manual

Fig.21
Clip-shaped hook
Insert the clip-shaped hook into a groove in the tool
housing, and then secure it with a hex bolt.
To remove the clip-shaped hook, loosen the bolt and
then take the hook out.
Fig.22
1. Clip-shaped hook 2. Hex bolt
Clip-shaped hook
Aligning the two sets of bolt holes, place the C-shaped
hook on the tool housing with the opening of the
C-shaped hook faces upwards. Tighten the C-shaped
hook with two hex bolts.
To remove the C-shaped hook, loosen the bolts and
then take the hook out.
Fig.23
1. C-shaped hook 2. Hex bolts
The C-shaped hook can be positioned open at
90-degree intervals.
Push and hold the hook upwards and swing it to your
desired position.
Fig.24
1. C-shaped hook
Hex wrench storage
Keep the hex wrench supplied ready on the wrench
holder while it is not in use.
Fig.25
1. Hex wrench 2. Wrench holder

OPERATION

Testing safety system
WARNING:
in working order before operation. Failure to do
so may cause personal injuries.
13 ENGLISH
Make sure all safety systems are