Table of Contents
Advertisement
Fig.26
1. Switch trigger 2. Contact element 3. Magazine
4. Nail pusher
Test safety system as follows for possible fault or mal-
function before operation.
1.
Remove the battery cartridge from the tool. Then
unload all the nails left in the magazine.
2.
Install the battery cartridge in place and turn the
tool on.
3.
Pull the switch trigger without placing the contact
element against the material.
4.
Pull the nail pusher towards the magazine slit and
hold it in place. Then place the contact element against
the material without pulling the switch trigger.
If the tool works in case step 3 or 4 described above,
safety system is not functioning properly. Stop using
the tool immediately and ask your local Makita Service
Center.
Driving nails
WARNING:
Continue to place the contact
driven completely.
CAUTION:
Before installing the battery car-
tridge into the tool, always check to see that the
switch trigger actuates properly and returns to
the "OFF" position when released.
CAUTION:
Do not drive nails on hard mate-
rials such as metal or the like. If the nail cannot
penetrate the material, the nailer may be kicked back
CAUTION:
operation.
NOTICE:
The tool will not start fastening after
the switch trigger or the contact element is being
solely actuated. Release the switch trigger or
pull the contact element free from the workpiece,
and then reposition the tool in place to restart
fastening.
NOTE: If you drive nails continuously for a long time,
the exhaust air will get hot due to the heat from the
motor.
The tool employs two nailing actions; full sequential
actuation and contact actuation.
NOTE: Only a single nailing mode (full sequential
actuation) is available in some regions or countries.
The switch design varies depending on your region
of residence.
Full sequential actuation
In this mode, you can drive one nail by one sequential
operation.
A workpiece contact and then a trigger need to be
Release and re-activate the switch controls in the same
sequence to continue driving nails.
1.
Press and hold the main power button to turn on
the tool.
2.
Make sure that the sequential actuation mode
lamp lights up.
Fig.27
1. Actuation mode switch button 2. Sequential
actuation mode lamp
3.
Fig.28
1. Contact element
4.
Pull the switch trigger fully to drive a nail.
14 ENGLISH
Advertisement
Table of Contents
