ETC ColorSource PAR jr Floor Stand Yoke Installation Manual

ETC Installation Guide
ColorSource PAR jr Floor Stand Yoke
O verview
The Floor Stand Yoke is an optional accessory for the ColorSource
PAR jr that replaces the standard yoke with an expandable yoke for
placing the fixture on the floor.
The expandable yoke can still be used for mounting the fixture on a
pipe using a C-clamp or truss clamp.
WARNING:
before installing accessories or performing any cleaning and maintenance.
AVERTISSEMENT :
et laissez-le refroidir avant d'installer des accessoires ou d'effectuer un
nettoyage ou un entretien.
CAUTION:
kickstand is open to the widest possible position for stability (see image above).
The kickstand should be oriented toward the front of the fixture for maximum
stability.
Installation
Tools required: 10 mm wrench, 5 mm wrench, and Phillips screwdriver
Remove Standard Yoke
1. Remove the bolts, washers, and yoke locking knob
that secure the yoke to the fixture.
2. Remove the yoke, but retain the yoke hardware
for installing the Floor Stand Yoke.
Corporate Headquarters n Middleton, WI, USA | +1 608 831 4116
Global Offices n London, UK | Rome, IT | Holzkirchen, DE | Paris, FR | Hong Kong | Dubai, UAE | Singapore
New York, NY | Orlando, FL | Los Angeles, CA | Austin, TX | © 2024 Electronic Theatre Controls, Inc.
Web
Trademark and patent info:
Product information and specifications subject to change. ETC intends this document to be provided in its entirety.
7420M2110 Rev A Released 2024-02
Disconnect the fixture from power and DMX and allow it to cool
Débranchez le projecteur de son alimentation et du DMX
When using the yoke as a floor stand, ensure that the yoke
etcconnect.com | Support support.etcconnect.com
etcconnect.com/ip
| Contact etcconnect.com/contactETC
| Third-party license agreement info: etcconnect.com/licenses