Troubleshooting - Smeg SW108D Manual

7 Troubleshooting

factory settings. (See "Canceling the programme")
Water in the machine.
distribute the load by hand to balance it homogenously in the machine.
Machine stopped shortly after the programme started.
voltage restores to the normal level.
in adequate amount of water. The machine will wait until there is sufficient amount of water to avoid
poor washing results due to lack of water. Timer indicator will resume countdown after this.
the selected temperature.
activated due to the unbalanced distribution of the laundry in the drum.
C
Foam is overflowing from the detergent drawer.
wash compartment of the detergent drawer.
C
and etc), reduce the amount of detergent.
C
A
dealer or the Authorized Service Agent. Never try to repair a nonfunctional product yourself.
Press and hold Start / Pause button for 3 seconds to reset the machine to
This is not a failure; water is not harmful to the machine.
Mix 1 tablespoonful softener and ½ l water and pour into the main
Adjust the feet to level the machine.
Clean the pump filter.
Remove the transportation safety bolts.
Add more laundry to the machine.
Take out some of the laundry from the machine or
Make sure that the machine is not leaning on anything.
Timer indicator will not countdown until the machine takes
Timer indicator will not countdown until the machine reaches
Automatic unbalanced load detection system might be
Use recommended amount of detergent.
EN
It will resume running when the