Preparing The Remote Controller; Charging; Powering On And Off - dji FPV Remote Controller 3 User Manual

Hide thumbs Also See for FPV Remote Controller 3:

Table of Contents

DJI FPV

Remote Controller 3 User Manual

Preparing the Remote Controller

Connect the charger to the USB-C port on the remote controller, and charge the remote

controller until at least three LEDs are lit up.

• It is recommended to use a USB charger that supports an output of 5 V/2 A or above

to charge the device.

• Make sure the remote controller has enough power before each flight. The remote

controller beeps when the battery level is low.

• Fully charge the battery at least once every three months to maintain good battery

health.

Press the power button once to check the current battery level. If the battery level is too low,

charge before use.

Press once, then press and hold for two seconds to power the remote controller on or off.

Table of Contents

Show Quick Links

Table of Contents

Do you have a question about the FPV Remote Controller 3 and is the answer not in the manual?