Table of Contents
Advertisement
2 Coarse and Fine Drive
2.2 Assembly
16. Remove the disks (25).
17. Remove the axis (26) to the right and remove the gear wheel (27).
18. Remove the bearing (28) with the axis (22) to the left.
Figure 4:
Disassemble coarse and fine drive
2.2 Assembly
1.
Grease all parts with the indicated lubricants.
2.
Push the axis (22) into the bearing (28).
3.
Insert the composed axis (22) and bearing (28) into the stand from the left side.
4.
Insert the axis (26) into the stand from the right side.
5.
Assemble the gear wheel (27) from below into the stand.
6.
Apply Loctite 222 to the thread of the flange (20) and tighten it with the disks (25)
from the left to the bearing (28).
7.
Adjust the flange with the fastening key (service tool b) as far as it can be moved up
and down with a torque of 50 N or 5 kg.
8.
Assemble the ring (21).
9.
Insert the ball bearing (24) and tighten the nut (23).
10. Hold the gear wheel of the axis (22) with the fastening key (service tool a) and slightly
tighten the nut (23) with an Allen Key 16 mm.
D-8
Service Manual Leica DM2700 M/P, Part D: Service and Maintenance
Version 02
Advertisement
Chapters
Table of Contents
