Maintenance And Cleaning; Specifications - Whirlpool Easy Dismantle Series Operating Instructions Manual

MAINTENANCE AND CLEANING:
X Always be sure that the power supply is disconnected before maintenance.
1. Always clean the oil cups and retainers by detaching or turning in anti-clockwise
and re-install properly to prevent oil spillage. -
2. After each operation, please wipe the unit with a dry cloth or a wet cloth, do not use
abrasive cleaner. :
3. It must use only foamless hood cleaner for cleaning process to avoid damage to
the unit, dilute the hood cleaner with water for cleaning (the recommended water and
cleaner is 30:1 to save the energy as the inner compartment is coated with Non-stick
coating layer that makes cleaning very easy.
4. Do not distort the exhaust fan or deformed the impellor.
EASY DISMANTLING PROCEDURES:
1. Bottom damper dismantle: Unfasten the safety screw by hand then turning the knob
of dismantling inward 90 ° .
2. This appliance is equipped with Auto cut-off device when the damper is dismantled.
3. Impellor discharge: Dismount the oil collector then turning the cap of impellor in
clockwise and re-install it properly.
Caution: The impellor designed for left and right position, do not re-install it in
wrong way.
※ EASY TO DISMANTLE, DO NOT NEED ANY TOOL DURING THE WHOLE
PROCESS.
1.Knob for dismantling
2. Clip for oil collector
3. Cap for impeller
SPECIFICATIONS:
VOLTAGE | FREQUENCE; WATTS WATTS | Wx Dx H(mm)
50Hz <25W 710X540X132