Maintenance & Cleaning - Whirlpool HC338 Use, Care And Installation Manual

1. Always disconnect from power supply before
cleaning.
2. Clean both exterior and interior of the hood
for long lasting.
3. Fan protection grille can be detached for cleaning
by removing the screws with a screwdriver.
lt must be reinstalled after cleaned.
4. Oil dish on the grille can also be detached for
cleaning by turning the dish anti-clockwise.
5. The oil cup in the centre of the hood for holding
grease can be detached and cleaned regularly.
6. Make a habit to turn on the hood before using
stove to avoid high heat in the kitchen.
7. The two easy dismantle rotary knobs are set
bottom panel, please turn them anti-clockwise
to" "then loosen safety screw to dismount
the bottom panel. It is easy to clean and repair.
To turn easy dismantle rotary knobs to "∣" and
fasten the safety screw to set bottom panel back.
8. Please must disconnect power before installing
light bulb. To refer Item 7 to dismount bottom panel
and then fasten/loosen light bulb with socket.
Note: For HC338 / HC768 / HC638 / HC646 /
HE568 / HE438 / HE2421, they can be
replaced with 4W max. LED light bulb or
14W max. energy saving lamp.
The light bulb MUST be equipped with
international safety mark.
9. After turned the easy dismantle rotary knobs to
dismantle the bottom panel, please remove the
two residue pans before taking out the bottom
panel from hood.
10. Please make sure the motor caps are tightened
properly after clean avoiding abnormal vibration.
M
AINTENANCE
& C
LEANING
12
Remove
Assembly
Clockwise to install
Anti-clockwise to detach
Easy dismantle rotary knobs
Safety screw
Motor cap