Advertisement
INSTALLATION AND USE
GB
For installation: The minimum distance between the support surface of the recipients on the cooking device
and the lowest part of the hood must not be less than 60 cm in the case of electric cookers and 70 cm for gas or
combination cookers. If the installation instructions for the gas cooker specify a greater distance, this must be
taken into account. It is advisable to contact a qualified technician for installation.
WARNING: Very heavy product; hood handling and installation must be carried out by at least two persons.
Note on installation and use: Read this manual before installing or using the hood. The Manufacturer declines
all liability for any faults, damage or fires caused by the appliance as a result of failure to observe the instructions
and recommendations given in this manual.
5019 318 33260
3
GB
F
NL
E
I
Advertisement
Table of Contents
Related Manuals for Whirlpool Cooker hoods
Summary of Contents for Whirlpool Cooker hoods
- Page 1 INSTALLATION AND USE For installation: The minimum distance between the support surface of the recipients on the cooking device and the lowest part of the hood must not be less than 60 cm in the case of electric cookers and 70 cm for gas or combination cookers.
- Page 2 5019 318 33260...
- Page 3 * only present on some models 5019 318 33260...
- Page 4 Grease filter Carbon filter 5019 318 33260...
-
Page 5: Safeguarding The Environment
SAFEGUARDING THE ENVIRONMENT 12. The appliance is not intended for use by children or persons with limited physical, sensory or mental abilities or without 1. Packing experience and knowledge of it, unless they are under the Packing materials are 100% recyclable and are marked with the supervision of or instructed in its use by a person responsible recycling symbol .Comply with the local regulations for... -
Page 6: Electrical Connection
Electrical connection AFTER-SALES SERVICE Before calling the After-Sales Service The mains voltage must match that given on the rating plate 1. Check to see if you can fix the problem yourself (see located inside the hood. If provided with a plug, connect the “Troubleshooting Guide”). - Page 7 Extractor hood installation (A): fumes are extracted and expelled to the outside through an exhaust duct fixed to the flange C (bayonet coupling). Always shut off the unused exhaust outlet with the plug D1 provided (if provided- bayonet coupling). Important! In some models, in order to use the rear exhaust outlet B2 the plastic part D2 or D3 must be removed first. Use pliers and a cutter to remove it.
Need help?
Do you have a question about the Cooker hoods and is the answer not in the manual?
Questions and answers