Removing And Refitting The Door; Replacing The Lamp - Whirlpool OMR35HR0B Manual

REMOVING AND REFITTING THE DOOR

1.
To remove the door, open it fully and lower the
catches until they are in the unlock position.
2.
Close the door as much as you can.
Take a firm hold of the door with both hands – do not
hold it by the handle.
Simply remove the door by continuing to close it
while pulling it upwards (a) at the same time until it is
released from its seating (b).
~60°
Put the door to one side, resting it on a soft surface.
3.
Refit the door by moving it towards the oven,
aligning the hooks of the hinges with their seating
and securing the upper part onto its seating.
4.
Lower the door and then open it fully.
Lower the catches into their original position: make
sure that you lower them down completely.
5.
Try closing the door and check to make sure that it
lines up with the control panel. If it does not, repeat
the steps above.

REPLACING THE LAMP

Disconnect the oven from the power supply, unscrew
the cover from the light, replace the bulb and screw
the cover back on the light. Reconnect the oven to
the power supply. Do not use the oven until the light
cover has been refitted.
Please note: Only use 25W/230 ~ V, G9 type, T300°C halogen
bulbs. The bulb used in the product is specifically designed
for domestic appliances and is not suitable for general room
lighting within the home. Light bulbs are available from our
After-sales Service.
CLEANING OF DOOR GLASSES
1.
After removing the door and resting it on a soft
surface with the handle downwards, simultaneously
press the two retaining clips and remove the upper
edge of the door by pulling it towards you.
~15°
b
2.
Lift and firmly hold the inner glass with both
hands, remove it and place it on a soft surface before
a
cleaning it.
3.
To correctly reposition the inner glass, make sure
that the "R" is visible in the left-hand corner. First
insert the long side of the glass indicated by "R" into
the support seats, then lower it into position.
4.
Refit the upper edge: a click will indicate correct
positioning. Make sure the seal is secure before
refitting the door.
7