Table of Contents
Advertisement
CLEANING AND MAINTENANCE
Make sure that the oven has
cooled down before carrying
out any maintenance or
cleaning.
Do not use steam cleaners.
EXTERIOR SURFACES
• Clean the surfaces with a damp microfibre cloth.
If they are very dirty, add a few drops of pH-
neutral detergent. Finish off with a dry cloth.
• Do not use corrosive or abrasive detergents. If
any of these products inadvertently comes into
contact with the surfaces of the appliance, clean
immediately with a damp microfibre cloth.
INTERIOR SURFACES
• After every use, leave the oven to cool and then
clean it, preferably while it is still warm, to remove
any deposits or stains caused by food residues. To
dry any condensation that has formed as a result
of cooking foods with a high water content, let the
oven to cool completely and then wipe it with a
cloth or sponge.
• Clean the glass in the door with a suitable liquid
detergent.
• The oven door can be removed to facilitate
cleaning.
ACCESSORIES
Soak the accessories in a washing-up liquid solution
after use, handling them with oven gloves if they
are still hot. Food residues can be removed using a
washing-up brush or a sponge.
REPLACING THE LAMP
• Disconnect the oven from the power supply.
• Unscrew the cover from the lamp, replace the bulb
and screw the cover back on the lamp.
• Reconnect the oven to the power supply.
Please note: Only use 15‑25 W/220‑240 V type G9, T300°C
halogen bulbs. The bulb used in the product is specifically
designed for domestic appliances and is not suitable for
general room lighting within the home (EC Regulation
244/2009).
Light bulbs are available from our After‑Sales Service.
When using halogen bulbs, do not handle them with your
bare hands as your fingerprints could cause damage. Do
not use the oven until the lamp cover has been refitted.
Do not use wire wool, abrasive
scourers or abrasive/corrosive
cleaning agents, as these could
damage the surfaces of the
appliance.
REMOVING AND REFITTING THE DOOR
To remove the door, open it fully and lower the
catches until they are in the unlock position.
Set the hinge lock to the widest angle. Adjust both
hinges connecting oven door to the oven to the same
position.
Later, close the opened oven door so that it will be in
a position to contact with hinge lock.
Fake a firm hold of the door with both hands – do
not hold it by the handle. Simply remove the door by
continuing to close it while pulling it upwards at the
same time until it is released from its seating.
Put the door to one side, resting it on a soft surface.
Reversely perform respectively what you did while
opening door to reinstall oven door back.
Wear protective gloves.
The oven must be disconnected
from the mains before carrying
out any kind of maintenance
work.
~15°
b
a
EN
Advertisement
Table of Contents
