Page 1
Keramische inductiekookplaat Istruzioni per uso e montaggio Piano di cottura ad induzione in vetroceramica Instrucciones para el uso y montaje Encimera vitrocerámica per inducción Manual de instruções de uso e de montagem Placa de cozinhar de indução em vitrocerâmica 225678 N71...
Instead it must be handed Please keep this manual in a safe place and pass it on to new over to a collection point for the recycling of owners for their information and safety.
Never allow them to play the fuse immediately and call Customer Service. with the appliance. • If the hob cannot be switched off due to a defect in the sensor • Attention! control immediately disconnect your appliance and call The surfaces of the heating and cooking zones become hot Customer Service.
3. Induction cooking zone back right 4. Induction cooking zone front right ON/OFF key 5. Touch-control operating panel This key is used to switch the respective cooking zones on and off. 6. Glass ceramic hob 7. Centre induction cooking zone...
If two or more sensor keys are pressed at the same time (e.g. If a cooking zone is switched on and there is no pan on the zone when a pan is mistakenly put onto a sensor key) no function will or if the pan is too small, there will be no transmission of power be activated.
Only use pots with a base suitable for induction. • The base of your cooking pots should be the same size as the cooking zone. Suitable cookware Unsuitable cookware •...
The timer can be used to automatically switch off the cooking zone after a certain period of time. Times ranging from 1 minute to 99 minutes can be set. 1. Select a power setting for the cooking zone and place a pan on the zone. 2. Press the plus key...
The cooking zones will have been released again. Note: • It is possible to switch the cooking zone off if the lock has been activated by means of pressing the ON/OFF key . The lock will remain activated.
Then dry again as described under Item 2. the hob with a clean dry cloth to ensure that there is no detergent left on the surface of the hob. Grains of sand which may get onto the hob when you peel...
If cracks, fractures or any other defects appear in your glass ceramic hob, immediately switch off the appliance. Disconnect • Are the sensor keys partly covered by a damp cloth, fluid or a the fuse immediately and call Customer Service.
Instructions for assembly • Veneers, adhesives and plastic surfaces of surrounding • The back wall of the bottom cabinet must be open in the area furniture must be temperature resistant (>75°C). If the veneers of the cut-out in order to provide for air circulation.
Page 12
(a), align it (b) and insert the clips (c). • Screws may be used to fasten the clips. Important! There is a risk of breakage if the hob is canted or subjected to stress during installation! Minimum distance to adjacent walls...
• The connection cable must be at least H05 RR-F. • If the excess cable of this appliance is damaged, it has to be replaced by the manufacturer, the Customer Service of the * Attention! Special power supply 230 - 240 V 3~ ! manufacturer or by another qualified person to avoid danger.