Page 1
INSTRUKCJA OBSŁUGI I MONTAŹU HASZNÁLATI ÉS BESZERELÉSI UTASÍTÁS РУКОВОДСТВО К ПОЛЬЗОВАНИЮ И УСТАНОВКЕ Piano di cottura da incasso in vetroceramica con comandi Touch Control Built-in glass ceramic hob with Touch-Control switches Plaque de cuisson vitrocéramique à encaster avec commande Touch-Control...
You now own a glass ceramic hob with Touch-Control switches. Chapters 2 and 3 of these Operating Instructions contain information on how you can make sure that your hob gives many years of service. These Operating Instructions are for use with several types of hobs. The nameplate on the front of these Instructions will show you which type you have bought.
Select a cooking level from 1 to 9 by means of the minus or plus keys . When switched on, each cooking zone § can be switched off again at any time. To do this, the required cooking zone must be activated, the stand-by dot lights up. The minus key can be used to turn the cooling level down to "0";...
Page 4
Pot Recognition (PR) If your range is equipped with Pot Recognition the PR will check whether a metal pot is on the cooking zone after a cooking level has been selected. If no pot is recognized, a u will appear in the display and the heating element will remain inactive.
Page 5
"00", or alternatively this can be done by simultaneously pressing the minus and the plus keys The timer can also be used as an egg timer when none of the cooking zones are activated. In this case, no cooking §...
Always use a lid. Energy is wasted if you cook without a lid placed correctly on the pan. In order to work directly on the cook zones, you can use cooking utensils made from fireproof glass or porcelain if their bottoms are flat polished. Please heed the manufacturer’s instructions.
3. Cleaning and Care Always clean the hotplates after they have cooled down. Even the slightest amount of dirt will burn into the surface the next time you switch it on. Use only recommended cleaners. Steel wool, cleaning sponges and abrasive powders scratch the surface.
When connecting the electrical appliance, install an all-pole disconnecting device with a contact gap of at least 3 mm. Make sure that the local mains voltage is the same as the voltage on the nameplate. To connect the appliance, unscrew the switchbox cover on the underside of the appliance to access the terminal block.
Before installing the hob, check that the all-round hob seal has no gaps. If the hob is installed in a worktop with a ceramic or similar cover (tiles), remove the hob seal and seal the hob from the worktop with a plastic seal, such as heat-resistant silicone rubber.
Page 10
Fastening in worktops made of wood and similar material Fig.1 Fig.2 Type: SE2756TC Fig.1 Fig.2 Fig.4 Fig.3 Minimum distance to adjacent walls Cut-out dimension Outside dimensions of recess Cable routing in rear wall Fastening in worktops made of granite or similar material Fig.2a Fig.3a 223175...