Replacing The Lamp; Troubleshooting - Whirlpool OMSK58CU1B Quick Manual

REPLACING THE LAMP

1. Disconnect the oven from the power supply.
2. Unscrew the cover from the light, replace the bulb
and screw the cover back on the light.
3. Reconnect the oven to the power supply.
CLEANING OF THE DOOR GLASSES
1. After removing the door and resting it on a soft
surface with the handle downwards, simultaneously
press the two retaining clips and remove the upper
edge of the door by pulling it towards you.
2. Lift and firmly hold the inner
glass with both hands, remove it and place it on a soft
surface before cleaning it.

TROUBLESHOOTING

Problem
The oven is not working.
The display shows the letter "F"
followed by a number or letter.
The display is showing the
message "Hot" and the selected
function will not start.
The display shows unclear text
and appears to be broken.
Policies, standard documentation and additional product information can be found by:
• Visiting our website docs . whirlpool . eu
• Using QR Code
Alternatively, contact our After-sales Service (See phone number in the warranty booklet). When
•
contacting our After-sales Service, please state the codes provided on your product's identification
plate.
8
Possible cause
Power cut.
Disconnection from the
mains.
Oven failure.
Temperature too high.
Another language set.
Please note: Use 25 W/230 V type G9, T300 °C halogen lamps.
The bulb used in the product is specifically designed for
domestic appliances and is not suitable for general room
lighting within the home (EC Regulation 244/2009).
Light bulbs are available from our After-sales Service. - Do not
handle bulbs with your bare hands as your fingerprints could
damage them. Do not use the oven until the light cover has
been refitted.
3. Refit the intermediate pane (marked with "R")
before refitting the inside pane: To position the
panes of glass correctly, make sure that the "R" mark
can be seen in the left-hand corner. First insert the
long side of the glass marked "R" into the support
seats, then lower it into position. Repeat this
procedure for both panes of glass.
4. Refit the upper edge: A click will indicate correct
positioning. Make sure the seal is secure before
refitting the door.
Solution
Check for the presence of mains electrical power
and whether the oven is connected to the electricity
supply. Turn off the oven and restart it to see if the
fault persists.
Contact you nearest Client After-sales Service Centre
and state the number following the letter "F".
Allow the oven to cool down before activating the
function. Select a different function.
Contact your nearest Client After-sales Service
Center.
Model: xxxXXXXxx XXXXXXXXXXXXXX