Control - Introduction; Display Unit - Nibe S1156PC User Manual

Control - Introduction

Display unit

THE STATUS LAMP
The status lamp shows how well your system is operating.
It:
• lights up white during normal operation.
• lights yellow in emergency mode.
• lights red in the event of a deployed alarm.
• flashes white during active notice.
• is blue when S1156PC/S1256PC is switched off.
If the status lamp is red, you receive information and sug-
gestions for suitable actions on the display.
TIP
You also receive this information via myUplink.
THE USB PORT
Above the display, there is a USB port that can be used e.g.
for updating the software. Log into
the "General" and then "Software" tab to download the latest
version of the software for your installation.
6 Chapter 3 | Control - Introduction
Status lamp
USB port
On/off button
Display
myuplink.com and click
THE ON/OFF BUTTON
The on/off button has three functions:
• start
• switch off
• activate emergency mode
To start: press the on/off button once.
To switch off, restart or activate emergency mode: press
and hold the on/off button for 2 seconds. This brings up a
menu with various options.
For hard switch off: press and hold the on/off button for 5
seconds.
To activate emergency mode when S1156PC/S1256PC is
switched off: press and hold the on/off button for 5 seconds.
(Deactivate the emergency mode by pressing once.)
THE DISPLAY
Instructions, settings and operational information are shown
on the display.
NIBE S1156PC/S1256PC